Pumps - SACEMI

Immersion pumps EPC series

General features

They are suitable for transferring clean liquids containing impurities up to 0.03 mm in size.
Their hydraulic components: impeller in brass, feed screw and pump body in cast-iron allow them to be used with emulsions and oily substances, glycol and liquids in general provded they are not oxidative for the construction materials.
Viscosity must not exceed 21 cST (3° Engel). The temperature of the liquid must not exceed 90°C.

They are commonly used on:
- drilling centres
- cooling units

They are normally installed on a tank with a capacity which is proportional to their flow rate, about 3-4 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 3-4 cm lower than the support flange.

Products:

AREM code	Pump model	Input kW.	Height of suction mm
1607401	EPC 63C	0,37	100
1607402	EPC 63C	0,37	130
1607403	EPC 63C	0,37	180
1607404	EPC 63C	0,37	230
1607405	EPC 63C	0,37	280
1607406	EPC 63C	0,37	360
1607407	EPC 71B	0,90	100
1607408	EPC 71B	0,90	130
1607409	EPC 71B	0,90	180
1607410	EPC 71B	0,90	230
1607411	EPC 71B	0,90	280
1607412	EPC 71B	0,90	360
1607413	EPC 80B	1,50	100
1607414	EPC 80B	1,50	130
1607415	EPC 80B	1,50	180
1607416	EPC 80B	1,50	230
1607417	EPC 80B	1,50	280
1607418	EPC 80B	1,50	360
1607419	EPC 90A	1,80	115
1607420	EPC 90A	1,80	145
1607421	EPC 90A	1,80	195
1607422	EPC 90A	1,80	245
1607423	EPC 90A	1,80	295
1607424	EPC 90A	1,80	375
1607425	EPC 90B	3,00	140
1607426	EPC 90B	3,00	170
1607427	EPC 90B	3,00	220
1607428	EPC 90B	3,00	270
1607429	EPC 90B	3,00	320
1607430	EPC 90B	3,00	400

Download data sheet