They are suitable for transferring liquids containing impurities up to 2 mm in size (3mm for AP 90).
Their hydraulic components: impeller and feed screw in cast iron, pump body in cast iron/steel allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel).
The temperature of the liquid must not exceed 90°C.
They are commonly used on:
- machine tools (milling and turning machines-machining centres)
- glass processing machinery
- surface treatment plants
- filtration systems
They are normally installed on a tank with a capacity which is proportional to their flow rate, about 6-7 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 3-4 cm lower than the support flange (see figure).
Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.
Products:
| AREM code |
Pump model |
Input kW. |
Height of suction mm |
| 1607201 | AP 80/B | 2,20 | 320 |
| 1607202 | AP 80/B | 2,20 | 450 |
| 1607203 | AP 80/B | 2,20 | 610 |
| 1607204 | AP 80/B | 2,20 | 860 |
| 1607205 | AP 90/A | 2,70 | 320 |
| 1607206 | AP 90/A | 2,70 | 450 |
| 1607207 | AP 90/A | 2,70 | 610 |
| 1607208 | AP 90/A | 2,70 | 860 |
| 1607209 | AP 90/B | 3,60 | 320 |
| 1607210 | AP 90/B | 3,60 | 450 |
| 1607211 | AP 90/B | 3,60 | 610 |
| 1607212 | AP 90/B | 3,60 | 860 |
| 1607213 | AP 100/A | 4,80 | 320 |
| 1607214 | AP 100/A | 4,80 | 450 |
| 1607215 | AP 100/A | 4,80 | 610 |
| 1607216 | AP 100/A | 4,80 | 860 |
| 1607217 | AP 112/A | 5,50 | 320 |
| 1607218 | AP 112/A | 5,50 | 450 |
| 1607219 | AP 112/A | 5,50 | 610 |
| 1607220 | AP 112/A | 5,50 | 860 |
| 1607221 | AP 122/B | 6,00 | 320 |
| 1607222 | AP 122/B | 6,00 | 450 |
| 1607223 | AP 122/B | 6,00 | 610 |
| 1607224 | AP 122/B | 6,00 | 860 |
